Installation Method Of Reducer

Correct installation, use, and maintenance of the reducer are important steps to ensure the normal operation of mechanical equipment. Therefore, when installing the reducer, please be sure to strictly follow the installation and use related matters below, and carefully assemble and use it.
The first step is to confirm whether the motor and reducer are in good condition before installation, and strictly check whether the dimensions of each part connecting the motor and reducer match. Here are the dimensions and fit tolerances of the positioning boss, input shaft, and reducer groove of the motor.
The second step is to unscrew the screws on the dustproof hole on the outer side of the reducer flange, adjust the clamping ring to align its side hole with the dustproof hole, and insert the inner hexagon and tighten it. Afterwards, remove the motor shaft key.
The third step is to naturally connect the motor to the reducer. When connecting, it is necessary to ensure that the concentricity of the output shaft of the reducer and the input shaft of the motor are consistent, and the outer flanges of the two are parallel. Inconsistent alignment can cause the motor shaft to break or the gearbox gear to wear.